TRNW-2: 47RE NV4500 countershaft no endplay

[FRANK GRIEVE]

 Interesting Jeff, I'll check into that and let you know!
    On Thursday, February 13, 2025 at 12:30:43 PM CST, Jeff Taylor <jefft74 at hotmail.com> wrote:  
 
 #yiv3546846632 P {margin-top:0;margin-bottom:0;}For some reason I think I did this once. I had the races switched from front to back. The taper was different on the two. I just built one last week and don't remember if that's possible,  lol Its been a rough few weeks.From: trnw2-bounces at trnw.net <trnw2-bounces at trnw.net> on behalf of Frank Grieve via trnw2 <trnw2 at trnw.net>
Sent: Thursday, February 13, 2025 12:24 PM
To: trnw2 at trnw.net <trnw2 at trnw.net>
Subject: TRNW-2: 47RE NV4500 countershaft no endplay Date: Thu Feb 13 9:24:30 PST 2025
Subject: 47RE NV4500 countershaft no endplay

2000 Dodge NV4500 replacing input, cluster, bearing and syncros for lube failure. The countershaft has no endplay. I'm certain the front bearing and race are bottomed out and the rear bearing is seated. The rear retainer sits about .060 from bottoming out on case. If I tighten the retainer it binds the shaft and i already ruined one bearing trying to pull it together. I'm tempted to put some washers under the rear retainer to get some endplay but gosh don't want to. Anybody ever comer across this?

Frank Grieve
Transmission Exchange Of Liberty
Liberty, Texas USA
TRNW Member Since: 9/11/2007

  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.trnw.net/pipermail/trnw2/attachments/20250213/7d9f9670/attachment.html>