TRNW-2: AX4S, o-ring the o-drive servo pin

[pat schulte]

I have cut oring grooves in pins before with a hacksaw blade or
cutoff wheel.

On Thu, May 22, 2025 at 12:57 PM Lee Hughes via trnw2 <trnw2 at trnw.net>
wrote:

> *Date:* Thu May 22 12:56:45 PDT 2025
> *Subject:* AX4S, o-ring the o-drive servo pin
>
> Hello Everyone , I would like to add an o-ring to the 0-drive. servo pin.
> I looked everywhere for chuck stansy # to get in touch with him as he said
> he has done this several times any way has anyone else ever done this
> modification that I could ask a few questions to. The trans is in the car
> and I would like to avoid pulling it. Thanks have a nice day! Lee
>
> Lee Hughes
> Hughes Precision Automotive
> Martinsville, Virginia USA
> TRNW Member Since: 9/14/2007
>
> This message was sent from the TRNW Technical Discussion Forum (trnw2).
> You were sent this message because you have subscribed to our mailing list.
> If you don't want to receive these emails from TRNW in the future, please
> unsubscribe here:
> https://www.trnw.net/unsubscribe.php?forum=2
> TRNW Inc., 2825 Walnut Terrace, Modesto, CA 95355



-- 
Pat Schulte
AAMCO Transmissions
Temecula, Ca.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.trnw.net/pipermail/trnw2/attachments/20250522/dd2879cd/attachment.html>