TRNW-2: 08 VW Passat Clutch position sensor

[Tod Chretien]

Sometimes the rod on the replacement master cylinder isn't the same 
length as the one that came off the vehicle. Not sure if that's your 
problem just something we recently went through.

-- 
Best Regards,
Tod Chretien
TRNW Inc.
http://www.trnw.net

On 6/30/2025 6:08 AM, John Lovell via trnw2 wrote:
> We installed a clutch and master cylinder in this last fall. Sets 
> clutch pedal code. Can't find much in Shop Key. Any of you VW guru's 
> have any thoughts? It is plugged in. I would guess it's working 
> because you have to press the clutch to start. Is there a reset 
> procedure? Thanks.
>
> John
>
>
>
> This message was sent from the TRNW Technical Discussion Forum (trnw2). You were sent this message because you have subscribed to our mailing list. If you don't want to receive these emails from TRNW in the future, please unsubscribe here:
> https://www.trnw.net/unsubscribe.php?forum=2
> TRNW Inc., 2825 Walnut Terrace, Modesto, CA 95355
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.trnw.net/pipermail/trnw2/attachments/20250701/4a17ec2a/attachment.html>