TRNW-2: atec trans tool foot press parts

[Fred Whitaker]

 I made one with a pipe T and some bar stock. Had to drill/bur out the opposite side of the Tee for the foot press to go through. Tack weld the round bar stock in the other 2 holes of the Tee. I made it YEARS ago!
________________________________
From: trnw2-bounces at trnw.net <trnw2-bounces at trnw.net> on behalf of Steve Everett via trnw2 <trnw2 at trnw.net>
Sent: Wednesday, September 24, 2025 3:09 PM
To: Technical Discussion Forum <trnw2 at trnw.net>
Subject: TRNW-2: atec trans tool foot press parts

Does anyone know where I can get the cross bar that comes with the foot presses when you buy them ? the one with a hole in the middle so you can put a case like an A340 on top of the press , put the arms on the crossbar down into the case to remove the rear spring retainer,  about half the shops I've been in that piece is gone,  and I can't find one on the net as of yet,  Atec apparently is out of business ?  or at least I can't find their website

   Steve
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.trnw.net/pipermail/trnw2/attachments/20250925/a5e0c204/attachment.html>