TRNW-2: 2007 ford edge PCM

[William Chechel]

Circuit board medics has those. The last one I did came plug and play. We
replaced it due to a bad ignition coil. They are actually not that
expensive.

On Fri, Sep 26, 2025 at 3:03 PM Tod Chretien via trnw2 <trnw2 at trnw.net>
wrote:

> If you have that cloning software everyone is talking about I am sure
> you can.
>
> If you don't have the cloning software then I am not 100% sure, but my
> guess is No. If it has that PATS key then that's a hurdle in itself.
>
> --
> Best Regards,
> Tod Chretien
> TRNW Inc.
> https://www.trnw.net
>
>
>
> On 9/26/2025 11:51 AM, Ryan D via trnw2 wrote:
> > Can I put a used pcm in a 2007 ford edge?
> >
> > --
> > Ryan
> >
> > This message was sent from the TRNW Technical Discussion Forum (trnw2).
> You were sent this message because you have subscribed to our mailing list.
> If you don't want to receive these emails from TRNW in the future, please
> unsubscribe here:
> > https://www.trnw.net/unsubscribe.php?forum=2
> > TRNW Inc., 2825 Walnut Terrace, Modesto, CA 95355
>
> This message was sent from the TRNW Technical Discussion Forum (trnw2).
> You were sent this message because you have subscribed to our mailing list.
> If you don't want to receive these emails from TRNW in the future, please
> unsubscribe here:
> https://www.trnw.net/unsubscribe.php?forum=2
> TRNW Inc., 2825 Walnut Terrace, Modesto, CA 95355
>


-- 
Bill Chechel
Cell# 484-241-1072
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.trnw.net/pipermail/trnw2/attachments/20250926/7ba85bdf/attachment.html>