TRNW-2: 68rfe caged spring assembly

[Wayne]

It’s the only I’ve been able to get the piston to go down straight enough to keep from marring or cutting the seal. 
Wayne Garrick

> On Oct 10, 2025, at 4:08 PM, Brett Karulak via trnw2 <trnw2 at trnw.net> wrote:
> 
> 
> The spring assembly between UD molded piston and balance piston in the input drum assembly, where the tabs break off, at one of the shops I talk to, they break the rest of the tabs off and run it.  Do any of you do this?  I have always been getting new OE caged spring assemblies.
> 
> Thank you,
> Brett
> This message was sent from the TRNW Technical Discussion Forum (trnw2). You were sent this message because you have subscribed to our mailing list. If you don't want to receive these emails from TRNW in the future, please unsubscribe here:
> https://www.trnw.net/unsubscribe.php?forum=2
> TRNW Inc., 2825 Walnut Terrace, Modesto, CA 95355