TRNW-2: U241E question

[Steve Everett]

  Check for a ground wire around the passenger side of the head, many times
if someone has done a valve cover gasket or any work in that area,  they
don't securely put the ground wire that is in the area back where it
belongs or not clean and tight ,  I've seen them attached to a valve cover
bolt before ,   Also any other ground wires that are in the engine/trans
harness,  remove, clean and securely reattach

     Steve

On Mon, Mar 3, 2025 at 8:17 PM Ryan D via trnw2 <trnw2 at trnw.net> wrote:

> I worded that question wrong. The 3rd clutch stays applied all the time.
> Takes off in 3rd, shifts to 2nd
> Binds because 3rd is still on. The when 2nd releases its in 3rd and shifts
> to 4th on time. It's commanding the shifts as it should. It's just that the
> 3rd clutch is always on
>
> On Monday, March 3, 2025, Ryan D via trnw2 <trnw2 at trnw.net> wrote:
>
>> I have a 2004 U241E camry that appears to stay in 3rd all the time.
>> It came in with code p0776 pcs B performance or stuck off. Went thru
>> trans and looked ok. Replaced solenoid with non oem. Same thing. Replaced
>> pcm used same thing. Voltage on sol B is around 3 volts with key on and
>> running. Ground is around .5 volts. Here's a picture of the amps. Any
>> thoughts?
>> Thanks
>>
>>
>> --
>> Ryan
>>
>
>
> --
> Ryan
> This message was sent from the TRNW Technical Discussion Forum (trnw2).
> You were sent this message because you have subscribed to our mailing list.
> If you don't want to receive these emails from TRNW in the future, please
> unsubscribe here:
> https://www.trnw.net/unsubscribe.php?forum=2
> TRNW Inc., 2825 Walnut Terrace, Modesto, CA 95355
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.trnw.net/pipermail/trnw2/attachments/20250304/8bf9def6/attachment.html>